Rohde & Schwarz EMI Test ReceiverESCI - Editing of Numeric Parameters

Setting Parameters R&S ESCI
1166.6004.12 3.18 E-1
Editing of Numeric Parameters
The entry of numeric values is always made in a data entry window, which is displayed automatically
after selection of the parameter.
START FREQUENCY
10.2457535 GHz
ST
A
RT FREQUENCY OUT OF R
A
NGE
Head line with
p
arameter name
Editing line with
parameter value and unit
Status and messa
g
e line
The headline indicates the name of the instrument parameter, which has been selected. The entry is
made in the editing line. Subsequent to calling the entry window, the current parameter value including
the unit is displayed left-justified in the editing line. Status and error messages which refer to the current
entry are displayed in the third and (optionally) fourth line.
Note: Entry windows may be represented transparent (cf. DISPLAY - CONFIG DISPLAY menu)
Entry of a numeric value ! Call data entry window (cf. selection of parameters)
The editing line indicates the current value
Example: center frequency (frequency-sweep mode)
CENTER FREQUENCY
FREQ
1.5 GHz
Entry via number keys
! Enter required value via number keys.
Example:
2
0
0
CENTER FREQUENCY
200 MHz
ms
mV
MHz
dBm
Entry via cursor keys
! Cursor
or until obtaining the required value.
Example:
CENTER FREQUENCY
200 MHz