R&S ESCI Setting Parameters
1166.6004.12 3.19 E-1
Entry via spinwheel
! Rotate the spinwheel until reaching the required value.
The variation step size increases with increasing
rotational speed.
Turning the spinwheel clockwise increases the value,
turning it counterclockwise decreases the value.
Example:
CENTER FREQUENCY
1.75 GHz
Note: When the value is modified by means of the
spinwheel or the cursor keys the new value
is immediately set.
Terminating the entry ! Press one of the unit keys
The unit is entered in the entry window and the new
setting is accepted by the instrument.
For dimensionless quantities:
!Press the ENTER key or the spinwheel
The new setting is accepted by the instrument.
A few data entry windows close automatically whereas
others like the entry window for the start frequency
remain open even after termination of the entry. They
can be closed by pressing the ESC key.
If an error occurs, a corresponding error message is
displayed in the status line of the entry window, e.g.,
"Out of range", "Value adjusted", etc. In this case, the
new value is not accepted for the instrument setting.
Example:
0
CENTER FREQUENCY
0 Hz
out of range
ns
nV
Hz
dB.
Correcting the entry
Deleting an entry
! Position the cursor beside the digit which is to be
deleted using the cursor keys
or
.
! Press the BACK key. The entry left to the cursor is
deleted.
! Enter new numbers. The number is inserted to the left
of the cursor, the other numbers are shifted right.
To Next Page
Loading...
