R&S ESCI Analyzer - Frequency and Span
1166.6004.12 4.75 E-1
LAST SPAN
After changing the span setting the LAST SPAN softkey activates the previous
setting. With this function a fast change between overview measurement (FULL
SPAN) and detailed measurement (manually set center frequency and span) is
possible.
Note: Only values > 0 Hz are restored, i.e. a transition between time and
frequency domain is not possible.
IEC/IEEE-bus command ---
FREQ AXIS
LIN LOG
The FREQ AXIS LIN/LOG softkey switches between linear and logarithmic
scaling of the frequency axis Switchover is only possible if the stop/start
frequency ratio is ≥1,4.
IEC/IEEE-bus command SWE:SPAC LIN
To Next Page
Loading...
