Triggering the Sweep - Analyzer R&S ESCI
1166.6004.12 4.102 E-1
VIDEO POL
POS NEG
The VIDEO POL POS / NEG softkey selects the polarity
of the video signal.
Positive video polarity is to be selected e.g. for standard
L signals, negative video polarity for signals according
to the standards B/G/I/M (colour standard
PAL or NTSC). Default setting is VIDEO POL NEG.
IEC/IEEE-bus command: TRIG:VID:SSIG:POL NEG
LINES
625 525
The LINES 625 / 525 softkey selects the line system
currently in use.
Default setting is 625 LINES.
IEC/IEEE-bus command: TRIG:VID:FORM:LPFR 625
CCVS
INT EXT
The CCVS INT / EXT softkey selects the input channel
for the TV trigger input signal. An external CCVS signal
can be supplied via the corresponding connector at the
rear panel of the instrument.
IEC/IEEE-bus command: SENS:TV:CCVS INT
To Next Page
Loading...
