Limit Lines R&S ESCI
1166.6004.12 4.186 E-1
NEW LIMIT
LINE
EDIT LIMIT
LINE
See following Section "Entry and Editing of Limit Lines".
COPY
LIMIT LINE
The COPY LIMIT LINE softkey copies the data file describing the marked
limit line and saves it under a new name. In this way, a new limit line can be
easily generated by parallel translation or editing of an existing limit line. The
name can be arbitrarily chosen and input via an entry window (max. of 8
characters).
IEC/IEEE-bus command: CALC:LIM3:COPY 2 or
CALC:LIM3:COPY "GSM2"
LIMIT LINE
DELETE
The DELETE LIMIT LINE softkey erases the selected limit line. Before
deletion, a message appears requesting confirmation.
IEC/IEEE-bus command: CALC:LIM3:DEL
X OFFSET
The X OFFSET softkey horizontally shifts a limit line, which has been
specified for relative frequencies or times (X axis). The softkey opens an
entry window, where the value for shifting may be entered numerically or via
the rollkey.
Note: This softkey does not have any effect on limit lines that represent
absolute values for the X axis.
IEC/IEEE-bus command: CALC:LIM3:CONT:OFFS 10kHz
Y OFFSET
The Y OFFSET softkey vertically shifts a limit line, which has relative values
for the Y axis (levels or linear units such as volt). The softkey opens an entry
window where the value for shifting may be entered numerically or via the
rollkey.
Note: This softkey does not have any effect on limit lines that represent
absolute values for the Y axis.
IEC/IEEE-bus command: CALC:LIM3:LOW:OFFS 3dB
CALC:LIM3:UPP:OFFS 3dB
To Next Page
Loading...
