The upper table ACTIVE TRANSDUCER FACTOR / SET indicates the active transducer factor or the
set with the associated name, frequency range and unit. If no factor or set is active, NONE is displayed
in the table. Additional information can be entered in a comment line. If a transducer factor is active, the
selected interpolation is displayed in addition, if a set is active, the break setting is displayed.
The left table TRANSDUCER FACTOR comprises all the defined factors with name and unit. If the
number of defined transducer factors exceeds the number of possible lines in the table, the table will be
scrolled.
The right table TRANSDUCER SET comprises all the defined transducer sets with the corresponding
information.
Only one set or transducer can be activated. An already active transducer factor or set is switched off
automatically if another one is switched on. An activated transducer factor or set is marked with a check
sign.
TRANSDUCER
FACTOR
The TRANSDUCER FACTOR softkey sets the selection bar to
the position of the active transducer factor.
If no transducer factor is switched on, the bar is positioned to
the first line of the table.
IEC/IEEE bus commands CORR:TRAN:SEL <name>
CORR:TRAN ON | OFF
TRANSDUCER
SET
The TRANSDUCER SET softkey sets the selection bar to the
position of the active transducer set.
If no transducer set is switched on, the bar is set to the first line
of the table.
IEC/IEEE bus commands CORR:TSET:SEL <name>
CORR:TSET ON |OFF
To Next Page
Loading...
