R&S ESCI Recalling Data Sets
1166.6004.12 4.249 E-1
STARTUP
RECALL
The STARTUP RECALL softkey activates the selection of a data set which is
automatically loaded when the instrument is powered on and after PRESET.
For this purpose the Dialog Startup Recall is opened (analogously to DATA
SET LIST).
The field Files lists all data sets stored in the selected directory. The currently
selected data set is checked.
In addition to the data sets stored by the user, the data set FACTORY, which
specifies the settings of the instrument before it was last switched off
(Standby), is always present (when unit is delivered).
To select a data set, the entry focus is set to the corresponding entry by
means of the spinwheel and the data set is activated by pressing the
spinwheel or the ENTER key.
If a data set other than FACTORY is chosen, this data set will be loaded
when the unit is switched on or after pressing the PRESET key. Any settings
can be assigned to the PRESET key.
IEC/IEEE command: MMEM:LOAD:AUTO 1,"D:\user\config\test02"
To Next Page
Loading...
