R&S ESCI Recalling Data Sets
1166.6004.12 4.251 E-1
EDIT
PATH
The EDIT PATH softkey activates the input of the directory which will be used
in subsequent file operations.
The new path is included in the FILE MANAGEMENT table.
Use CURSOR UP / DOWN to select a drive and confirm your selection with
ENTER.
Open subdirectories by using CURSOR RIGHT, and use CURSOR LEFT to
close them again.
When you have found the subdirectory you looked for, mark it with ENTER.
IEC/IEEE command: MMEM:MSIS "a:"
MMEM:CDIR "D:\user "
NEW
FOLDER
The NEW FOLDER softkey creates subdirectories.
The entry of an absolute path name (e.g. "\USER\MEAS") as well as the path
relative to the current directory (e.g. "..\MEAS") is possible.
IEC/IEEE command: MMEM:MDIR "D:\user\test"
To Next Page
Loading...
