R&S ESCI Measurement Documentation
1166.6004.12 4.271 E-1
! Confirm the subsequent prompt to install a
suitable printer driver with "OK".
The list of available printer drivers is
displayed.
The manufacturers are listed in the left-
hand table, the available printer drivers in
the right-hand table.
! Select the manufacturer from the
Manufacturers table and then the printer
driver from the Printers table.
Note:
If the desired type of output device is not
shown in the list, the driver has not yet been
installed. In this case, click the "HAVE DISK"
button. You will be prompted to insert a disk
with the corresponding printer driver. Insert
the disk, select "OK" and then choose the
desired printer driver.
! Click Next.
If one or more printers are already installed,
a query is displayed whether the printer just
installed should be used as the standard
printer for the Windows XP applications.
Default setting is No.
! Start the printer driver installation with
Finish.
Finally, the instrument has to be configured for printout with this printer using the DEVICE SETUP and
DEVICE 1/2 softkeys in the hardcopy main menu (see section "Selection of a Printer).
To Next Page
Loading...
