Rohde & Schwarz EMI Test ReceiverESCI - Page 406

Tracking Generator - Option R&S FSP-B9 R&S ESCI
1166.6004.12 4.274 E-1
SOURCE
POWER
The SOURCE POWER softkey allows the tracking generator output power to
be selected.
The output power can be set in 0.1 dB steps from -30 dBm to 0 dBm.
If the tracking generator is off, it is automatically switched on when an output
power value is entered.
The default output power is -20 dBm.
IEC/IEEE-bus command: SOUR:POW -20dBm
POWER
OFFSET
The POWER OFFSET softkey allows selection of a constant level offset for
the tracking generator.
With this offset for example attenuators or amplifiers at the output connector
of the tracking generator can be taken into account for the displayed output
power values on screen or during data entry.
The valid range is -200 dB to +200 dB in 0.1 dB steps. Positive offsets apply
to an amplifier and negative offsets to an attenuator subsequent to the
tracking generator.
The default setting is 0 dB. Offsets <> 0 will display the enhancement label
LVL.
IEC/IEEE-bus command: SOUR:POW:OFFS -10dB