R&S ESCI LAN Interface
1166.6004.12 4.329 E-1
2. Install a fixed IP address for the TCP/IP protocol as described in the Section "Configuration of
Available Network Protocols (TCP/IP Protocol)".
Note:
Operation with a fixed IP address is strongly recommended.
When a DHCP server is used, a new IP address (which has to be determined first) will be assigned
any time the instrument is restarted. For this reason, a DHCP server would not be suitable for use
for detached operation of the R&S ESCI.
3. Enable the R&S ESCI for operation with the remote desktop.
! Press the Windows key or
<CTRL><ESC>.
The Windows start menu will be opened.
! Select Settings - Control Panel - System.
! Select the Remote tab.
! In the Remote Desktop field, tick the box
in front of Allow users to connect
remotely to this computer.
! If required, select the users installed on
the R&S FSP who are to also have
access to the R&S FSP via remote
desktop in the Select Remote Users...
dialog.
Note:
The user account under which the
configuration is to be performed is
automatically enabled for remote desktop.
! Confirm setting with OK .
The R&S ESCI is therefore ready for setting
up the connection with the remote desktop of
the controller.
To Next Page
Loading...
