R&S ESCI Example - Level and Frequency Measurement
1166.6004.12 2.3 E-2
PRESET
RECEIVER
1. Resetting the instrument and
2. Selecting the RECEIVER mode
! Press first the PRESET key and then the
RECEIVER hotkey.
The main receiver menu is opened. The receiver
mode is set.
The following screen is displayed:
Fig.2-1 Display after selecting the default setup in receiver mode
USE CURR
SETTINGS
USE SCAN
TABLE
SWEEP
USE SCAN
TABLE
3. Programming a SCAN table
! Press the SWEEP key.
! In the SWEEP menu press the USE SCAN TABLE
softkey.
A menu is displayed where the whole display range
can be defined and divided into scan subranges.
After PRESET a scan range of 150 kHz to 1 GHz is
preset on the frequency axis.
Now the stop frequency is set to 30 MHz.
To Next Page
Loading...
