Example - Level and Frequency Measurement R&S ESCI
1166.6004.12 2.12 E-2
SPLIT
SCREEN
FULL
SCREEN
DISP
! Press the DISP key in the SYSTEM field.
The SYSTEM DISPLAY menu is opened.
SPLIT
SCREEN
! Press the SPLIT SCREEN softkey.
Two windows are displayed on the screen.
9. Tuning the receiver frequency and obtaining
final test results using the QUASI-PEAK detector
The currently measured frequency can be rapidly
changed eg with the TUNE TO MARKER softkey in
the MKR→ menu. Other or additional detectors can
be switched on at this receive frequency and an
overview of levels of all active detectors is given.
For measurements to standard, the measurement
time must first be set to 1 s.
MKR
! Press the MKR key.
Marker 1 is displayed.
Frequency and level values can be read in the
marker field at the top left of the screen.
NEXT PEAK
PEAK
SELECT
MARKER
MKR
! Press the MKR→ key.
The MARKER → menu is opened.
TUNE TO
MARKER
! Press the TUNE TO MARKER softkey.
The current receive frequency is tuned to the
marker frequency.
A measurement time of 1 s must be set for
measurements to standard.
To Next Page
Loading...
