The Screen R&S ESCI
1166.6004.12 3.8 E-1
Message windows:
Message field
Message fields provide notes on measurements, e.g. results of the
limit check (PASS/FAIL).
These notes are no error messages, which are indicated as system
messages.
They can be masked out by pressing the ESC key.
System messages
System messages indicate warnings and error messages.
Message without action field:
These system messages contain only arbitrary information. They hint
at events which are of interest for the user but do not affect the
measurement or functioning of the instrument.
They are deleted either automatically after a predefined time has
passed (3 seconds) or upon any keystroke or mouse click.
Message with action field:
These system messages require a decision to be taken by the user.
They are not deleted until any action has been selected. Deletion of
the message initiates the action selected and appropriate measures to
be taken. The action field consists of one (OK), two (OK/CANCEL) or
three (arbitrary) buttons.
The user may select one of the buttons using the cursor keys and
initiate the associated action by means of the unit keys. The ESC key
is used to acknowledge the message without releasing any action.
Traces:
1 to 3
Up to 3 traces in each measurement diagram can be displayed
simultaneously.
Limit lines
Limit lines are used to mark level curves or spectral distributions which
must not be exceeded or dropped below.
The R&S ESCI provides two display modes:
• Full Screen: 1 window, the measurement is performed in the active diagram.
• Split Screen: 2 windows, the measurements are performed in both diagrams.
To Next Page
Loading...
