rotork p3 - Page 108

P3 - Pakscan Master Station Technical Manual
108 of 136 Publication PUB059-002-00 Issue 06/15
This page is used to set up the email alarm reporting from the system to the dedicated recipients as
specified in the user set up screen. Each system user may be specified to receive alarm messages as
emails or by text when their log-in credentials are specified. Refer to the section on Users to see how
this is set up. The Alarm page has two sections. The first deals with the way emails are to be
generated and the specifying of a suitable SMTP server, whilst the second specifies which events will
cause messages to be sent.
Alarm Email Settings
Email Alarm : Set to Enable or Disable the whole process.
SMTP Server : Specifies the server that the master station will use for forwarding emails.
This is either a domain name or IP address for the server on which the
email account has been set.
SMTP : If the domain server supports SMTP authentication, then set this to Enable
Authentication and complete the Authentication parameters. (More information on SMTP
Authentication can be found in RFC 4954 available on the internet.)
Authentication Method - auto, plain, login or cram-md5; usually set to login.
Username - the email user name for the master station or an identifier.
Password - the chosen verification password for authentication of the
messages from the master station to the server.
Sender : A name to identify the master station, it could be the tag name.
Reply Path : The email address of the master station or an alternative reply address for
return messages.
Test Email : Enter a valid email address to send a test message to in order to ensure the
system is working correctly; then click on ‘Test’.
Controls
Test : Sends a test email to the specified address.
Save Settings : Saves the ‘Alarm Email’ Settings.
FCU Alarm
This table lists the devices on the field network by address and tag number. The right hand
side box, when clicked, toggles between a tick and no tick. A tick indicates that if any alarm
occurs on this field unit, it will be reported by the email or text facility.
Controls
Clear All : Removes any ticks from all the boxes in the list.
Set All : Adds a tick in all the boxes in the list.
Save Settings : Saves the FCU Alarm list settings.
Event List
This table lists all the Master station and Option module alarms that can be used to initiate an
alarm email or text. The list is split into two parts relating to the CPU module and the Option
module(s).
Controls
Save Settings : Saves the Event List settings