7. Internal Web pages
Issue 06/15 Publication PUB059-002-00 81 of 136
Actuator Controls - Available to Write and Administrator user levels only
Open : Command to open the valve fully.
Stop : Command to stop the actuator in its present position.
Close : Command to close the valve fully.
ESD : Command to put the valve in its Emergency Shut Down position. (This can
be ‘stayput’ or move to either the open or closed position).
Pos DV : A slider control that is used to generate a setpoint position (Desired Value)
for the valve in the range 0 - 100%.
All the controls have a confirmation pop-up, so that the action has to be confirmed before it
takes place. Web page control must be enabled for these controls to work.
To Next Page
Loading...
