Sea-doo 2005 4-Tec models User Manual

Section 01 MAINTENANCE
Subsection 03 (STORAGE PROCEDURES)
Cooling system flushing should be performed
when the watercraft is not expected to be used
further the same day or when the watercraft is
stored for any extended time.
CAUTION: Failure to flush open loop cooling
system, when necessary, will severely dam-
age engine intercooler and/or exhaust system.
Make sure engine operates during entire pro-
cedure.

WARNING
Perform this operation in a well ventilated
area. Do not touch any electrical part or jet
pump area when engine is running.
Proceed as follows:
Clean jet pump by spraying water in its inlet and
outlet and then apply a coating of BOMBARDIER
LUBE lubricant (P/N 293 600 016) or equivalent.

WARNING
Always remove safety lanyard cap from post
to prevent unexpected engine starting before
cleaning the jet pump area. Engine must not
be running for this operation.
Procedure Using Flushing Connector
on Jet Pump Support
All Models
Connect a garden hose to connector located at the
rear of watercraft on jet pump support. Do not
open water tap yet.

WARNING
When operating the engine while the water-
craft is out of the water, the heat exchanger
intherideplatemaybecomeveryhot. Avoid
any contact with ride plate as burns may oc-
cur.
NOTE: The optional flushing connector adaptor
(P/N 295 500 473) can be used with a quick con-
nect adapter to ease garden hose installation.
1
F00E05A
2
1. Quick connect adapter
2. Flushing connector adapter
F07E01C
3
2 1
TYPICAL
1. Flushing connector
2. Quick connect adapter and flushing connector adapter (optional)
3. Garden hose
To flush the exhaust cooling system , start the
engine then immediately open the water tap.

WARNING
Certain components in the engine compart-
ment may be very hot. Direct contact may re-
sult in skin burn. Do not touch any electrical
part or jet pump area when engine is running.
CAUTION: Never flush a hot engine. Always
start the engine before opening the water tap.
Open water tap immediately after engine is
started to prevent overheating.
CAUTION: Never run engine without supplying
water to the exhaust cooling system when wa-
tercraft is out of water.
CAUTION: Never run engine longer than 5 min-
utes. Drive line seal has no cooling when wa-
tercraft is out of water.
Run the engine about 20 seconds at a fast idle
between 4000 - 5000 RPM.
Ensure water flows out of jet pump while flushing.
6 smr2005-004
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons