Sea-doo 2005 4-Tec models User Manual

Section01MAINTENANCE
Subsection 03 (STORAGE PROCEDURES)
Close the water tap, then stop the engine.
CAUTION: Always close the water tap before
stopping the engine.
Disconnect the garden hose.
CAUTION: Remove flushing connector adapter
after operation (if used).
Procedure Using Flushing Connector
in Engine Compartment
GTX 4-TEC Limited Models
This flushing connector allows to flush the exhaust
cooling system directly by the engine compart-
ment. The access is easier than the connector
on the jet pump support but requires the use of
a small hose pincher.
Remove seat to gain access.
1
2
F18E1TA
1. Flushing connector
2. Dust cap
Remove dust cap from flushing connector and at-
tach coupler hose (supplied with vehicle). Make
sure coupler hose is properly locked to flushing
connector.
Install a small hose pincher (P/N 295 000 076) (sup-
plied inside vehicle tool kit) on water outlet hose.
This prevent water from directly existing exhaust
cooling system.
295 000 076
This prevents water from directly exiting exhaust
cooling system.
12
F18E1UA
1. Coupler hose
2. Small hose pincher
Attach other end of coupler hose to a garden hose.
Do not open water tap yet.
To flush the exhaust cooling system, start the en-
gine then immediately open the water tap.

WARNING
Certain components in the engine compart-
ment may be very hot. Direct contact may re-
sult in skin burn. Do not touch any electrical
part or jet pump area when engine is running.
CAUTION: Never flush a hot engine. Always
start the engine before opening the water tap.
Open water tap immediately after engine is
started to prevent overheating.
smr2005-004 7
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons