Section 03 ENGINE SYSTEM
Subsection 05 (REMOVAL AND INSTALLATION)
All Models
1
F19D0BA
2
1. Battery ground
2. Engine grounds
GTX 4-TEC Series and RXT 4-TEC
Disconnect the throttle position sensor (TPS),
manifold air pressure sensor (MAPS) and man-
ifold air temperature sensor (MATS) (refer to
INTAKE section).
Refer to ENGINE MANAGEMENT for location of
sensors and connectors.
RXP 4-TEC Models
Remove engine cover. Refer to HULL AND BODY.
Remove connectors from engine connector
bracket then disconnect. Refer to WIRING DIA-
GRAMS.
Disconnect ECM and remove from engine to pre-
vent any possible damage while pulling engine
out.
3
F18Z0JB
1
2
1. Remove connectors
2. Disconnect ECM
3. Remove ECM
Unplug VTS connector.
Cut locking ties retaining vehicle wiring harness to
engine.
1
F19D06A
VEHICLE WIRING HARNESS
1. Cut locking tie
Move wiring harness forward to make room.
All Models
Exhaust Pipe
To remove exhaust pipe, refer to EXHAUST SYS-
TEM in ENGINE section.
60 smr2005-010
To Next Page
Loading...
