MRD 3187B - User Manual
Page 174 (245)
Connection 2
1. Use the
and
buttons to select
“Ip2:”, then press the
button.
2. Use the
and
buttons to
change the character and then the
and
buttons to change the IP
address, then press the
button to
save the selection.
3. Use the
and
buttons to select
“Port2:”, then press the
button.
4. Use the
and
buttons to
change the character and then the
and
buttons to change the
Port2 value, then press the
button to save the selection.
RW Community Setup
To change the RW Community, follow the steps below:
1. Use the
and
buttons to move the
cursor to “RW Community”, then press the
button.
Name
1. Use the
and
buttons to select
“Name:”, then press the
button.
2. Use the
and
buttons to
change the character and then the
and
buttons to change the
Name, then press the
button to
save the selection.
Connection 1
1. Use the
and
buttons to select
“Ip1:”, then press the
button.
2. Use the
and
buttons to
change the character and then the
and
buttons to change the IP
address, then press the
button to
save the selection.
3. Use the
and
buttons to select
“Port1:”, then press the
button.
4. Use the
and
buttons to
change the character and then the
and
buttons to change the
Port1 value, then press the
button to save the selection.
RW Community ←→
Name: private
---
Ip1:10.0.15.10
►Port1:0162
RW Community ←→
Name: private
---
►Ip1:010.000.015.010
Port1:0162
RW Community ←→
►Name:private
---
Ip1:10.0.15.10
Port1:0162
SNMP
RO Community
►RW Community
Trap Setup
RO Community ←→
Name:public
----
Ip2:0.0.0.0
►Port2:0162
RO Community ←→
Port1:0162
►Ip2:000.000.000.000
Port2:0162
To Next Page
Loading...
