Sencore MRD 3187B User Manual

MRD 3187B - User Manual
Page iv (245)
WARNING
PLEASE OBSERVE THESE SAFETY PRECAUTIONS
There is always a danger present when using electronic equipment.
Unexpected high voltages can be present at unusual locations in defective equipment
and signal distribution systems. Become familiar with the equipment that you are
working with and observe the following safety precautions.
Every precaution has been taken in the design of your MRD 3187B to ensure
that it is as safe as possible. However, safe operation depends on you the
operator.
Always be sure your equipment is in good working order. Ensure that all points of
connection are secure to the chassis and that protective covers are in place and
secured with fasteners.
Never work alone when working in hazardous conditions. Always have another
person close by in case of an accident.
Always refer to the manual for safe operation. If you have a question about the
application or operation call SENCORE for assistance.
Never allow your equipment to be exposed to water or high moisture
environments. If exposed to a liquid, remove power safely (at the breaker) and
send your equipment to be serviced by a qualified technician.
When installing the MRD 3187B utilizing the DC power supply, the power supply
MUST be used in conjunction with an over-current protective device rated at 50
V, 5 A, type: Slow-blo, as part of battery-supply circuit.

Sencore MRD 3187B Specifications

General

Brand	Sencore
Model	MRD 3187B
Category	Receiver
Language	English