SICK S3000 - Page 138

Chapter 11 Operating instructions
S3000
138 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8009942/WK81/2012-11-28
Subject to change without notice
Diagnostics
Display Possible cause Rectification of the error
   Direction of movement
output by the incre-
mental encoders is
different.
 Check the wiring of the incremental encoder
inputs, e.g. for incorrect pin assignments.
   Maximum frequency at
i
nput INC1 exceeded
 Check the incremental encoders.
 Check the configuration of the incremental
encoder inputs with the aid of the CDS.
 Check whether the permitted maximum
velocity of the vehicle is exceeded!
   Maximum frequency at
input INC2 exceeded
Or
The monitored speed
threshold has been
exceeded.
 Check the incremental encoders.
 Check the configuration of the incremental
encoder inputs with the aid of the CDS.
 Check whether the permitted maximum
velocity of the vehicle is exceeded!
 Check the limit velocity configured in the
related monitoring cases.
   Sensor head faulty
   I/O module faulty
   Configuration memory
in the system plug
faulty
 Switch off the voltage supply of the S3000
for at least 2 s and then switch it back on.
If the display does not go off:
 Send the sensor head, the I/O module or the
system plug to the manufacturer for repair.
   A second device which
is connected via EFI is
faulty.
 Check the connected device and the
connection.
  Overcurrent on OSSD
connection 1
 Check the switching element connected
(contactor, relay). Replace, if necessary.
 Check the wiring for short-circuit to 0 V.
  Short-circuit to 24 V at
OSSD connection 1
 Check the wiring for short-circuit to 24 V.
  Short-circuit to 0 V at
OSSD connection 1
 Check the wiring for short-circuit to 0 V.
  Overcurrent on OSSD
connection 2
 Check the switching element connected
(contactor, relay). Replace, if necessary.
 Check the wiring for short-circuit to 0 V.
 ! Short-circuit to 24 V at
OSSD connection 2
 Check the wiring for short-circuit to 24 V.
  Short-circuit to 0 V at
OSSD connection 2
 Check the wiring for short-circuit to 0 V.
 " Short-circuit between
OSSD connection 1
and 2
 Check the wiring and rectify the error.
  General OSSD wiring
error
 Check the complete wiring of the OSSDs.