SICK S3000 - Page 152

Chapter 12 Operating instructions
S3000
152 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8009942/WK81/2012-11-28
Subject to change without notice
Technical specifications
Minimum Typical Maximum
Input EDM
Input resistance when HIGH 2 kb
Voltage for HIGH 11 V 24 V 28.8 V
Voltage for LOW –3 V 0 V 5 V
Input capacitance 15 nF
Static input current 6 mA 15 mA
Response time at EDM after switching on
the OSSDs
300 ms
Static control inputs
Input resistance when HIGH 2 kb
Voltage for HIGH 11 V 24 V 28.8 V
Voltage for LOW –3 V 0 V 5 V
Input capacitance 15 nF
Static input current 6 mA 15 mA
Input frequency (switching sequence, max.
or frequency)
1/t
UFVz
+ half basic response time
(t
UFVz
= Time set for advancing the
timing for the switching)
Dynamic control inputs
Input resistance when HIGH 2 kb
Voltage for HIGH 11 V 24 V 28.8 V
Voltage for LOW –3 V 0 V 5 V
Input capacitance 1 nF
Static input current 6 mA 15 mA
Duty cycle (Ti/T) 0.5
Input frequency 100 kHz
Voltage supply for incremental encoders
24 V voltage output HIGH V
S
– 3 VV
S
Current load 50 mA 100 mA