Mounting and installation of the compact control panel
Installing an Ethernet switch (modular) FN2012
5
147 |
Building Technologies
1 Empty Comfort housing
2 Small mounting bracket
3 Lugs for recesses for securing the power supply (70W)
4 DIN rail installed
5 Retaining bracket installed
6 3x fixing screws for mounting bracket
7 3x sleeves for fixing to spacer
8 3x holes in mounting bracket for spacer
9 3x spacers with thread in rear panel
1. Position the small mounting bracket (2) as shown.
2. In the case of the Eco and Standard housings, please ensure that the tabs (3)
of the mounting bracket go into the recesses for the power supply (70 W).
3. Using the holes (8), push the mounting bracket (2) onto the spacers (9) that
have been pressed into the housing.
4. Place the sleeves (7) on the spacers (8) of the rear panel and use the fixing
screws (6) to secure the mounting bracket.
To Next Page
Loading...
