Mounting and installation of the compact control panels
Installing an Ethernet switch (modular) FN2012
5
155 |
Building Technologies
5.16.5.2 MoNet bus connection
Preparing the FN2012 for the MoNet bus connection
Figure 81: Breaking out the MoNet bus cover plate
l Use a screwdriver to carefully remove the cover plate from the MoNet
connector, as shown in the figure.
a By moving the screwdriver as a lever in the direction of the arrow, you will
release the cover plate at the four intended breakout points.
Connection for MoNet bus flat cable
Figure 82: Connecting the MoNet bus flat cable
l Connect the 1.35 m-long flat cable for the MoNet bus to the FN2012, as shown.
To Next Page
Loading...
