Setup of the compact control panels
Station rear panels (packaging unit)
3
25 |
Building Technologies
6 Recesses for the hinges of the operating unit
7 Mounting holes for operating unit
8 Periphery board
9 Secondary-side cabling of the power supply
10 Recesses for the hinges of the operating add-on
11 Mounting holes for the operating add-on
12 Power supply (150 W)
13 Holes for wall mounting (bottom)
14 Strain relief for mains supply cable
15 DIN rail with network separation terminals, also for additional components
16 Primary-side cabling of the power supply
To Next Page
Loading...
