Mounting and installation FC2080
Installing the battery tray (19")
6
280 | 354
5 8 threaded screws M6 x 12 for securing the crossbeam
6 Threaded holes for securing the compartment
7 2 crossbeams for the battery tray
8 Lateral crossbars with mounting holes
1. Install the battery tray (1) on the two crossbeams (7) with four countersunk
screws (3). Depending on the lateral cable guide, you can install the battery
tray in the three mounting holes (6) offset to the side.
2. Secure the entire battery tray (19") at the height you want on the lateral
crossbars (7) by inserting eight screws and nuts (5) through the mounting holes
in the crossbeams (4).
3. The installation process for the second battery tray (19") is identical to that of
the first. Ensure that you keep it a sufficient distance from the bottom battery
tray (note the height of the batteries).
To Next Page
Loading...
