Siemens FS20 - Page 339

Mounti
ng and installation of fire terminal (Touch)
Installation in rear panel (FT2080) FHA2039
7
339 |
354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
1. Position the wired-up fire terminal (Touch) (1) on the rear panel (7) as shown.
2. Screw the four fixing screws (2) through the holes (3) to secure the fire terminal
(Touch) (1) into the threaded holes (5) in the rear panel.
Installing the rear cover (FT2080) in a desktop
Figure 197: Installing the rear cover (FT2080) in a desktop
1 Rear panel (FT2080) FHA2039
2 Mounted fire terminal (Touch) FT2080
3 4x fixing screws
4 Mounting holes in the flanges of the rear panel (FT2080)
5 Bores in the desktop
6 Desktop
7 Cutout for rear panel (FT2080) min. 430 x 268 mm
1. Place the rear panel (1) in the cut-out of the desktop (6) as shown. Ensure that
the cables are not pinched.
2. Use the four fixing screws (3) to screw the rear panel (1) into the bores (5) of
the desktop at the flanges (4).
5
6
7
4
1
2
3