Mounting and installation of the compact control panels
Mounting and assembling a station
5
70 | 354
1 Hinge of the operating unit
2 Cable routing to the optional components
3 Cable ties for fixing the cables
4 Operating unit
5 Holes for securing the operating unit
6 Connection (X3) for the ribbon cable on the PMI & mainboard
7 Ribbon cable from the PMI & mainboard to the periphery board
8 Plastic clip for securing the ribbon cable
9 Connection (X3) for the ribbon cable on the periphery board
Figure 33: Detail view of the hinge of the operating unit
1 Cut-out section on the rear panel for the hinge of the operating unit
2 Hinge of the operating unit
3 Screw for securing the hinge
Mounting steps
1. From the rear side, hang the operating unit by inserting the hinges (2) into the
openings in the rear panel of the housing (1).
2. Hold the operating unit in place and secure the hinges (2) with the screws (3).
3. Insert the connection cable to the periphery board into the respective plug-in
positions (6 and 9) as shown in the figure.
4. Stick the supplied cable support to the inner right side of the station at the
same height as the cable and fix the flat cable.
5. Guide the cables (2) of the operating unit options to the station as indicated
and fix these cables with cable ties (3).
6. Insert the supplied inscription strips underneath the operating unit foil as shown
in the illustration.
7. Swivel the operating unit towards the station and secure it using the four
screws.
1
2
To Next Page
Loading...
