Siemens FUS1010 - Page 120

Functions
7.6 Analog Input Setup
FUS1010 IP65 NEMA 4X & IP66 NEMA 7
Operating Instructions, 01/2013, A5E02951520-AC
119
Setting the Analog Current Input
The DC current input port must be enabled first. From the [Analog Inp Setup] menu proceed
as follows:
,2'DWD&RQWURO
6LHPHQV 'XDO3DWK>@3DWK
$QDORJ,QSXW6HWXS
$QDORJ2XW6HWXS
5HOD\6HWXS
$QDORJ,QS6HWXS
1. Access the [Iin1] option list by pressing the <Right Arrow> twice.
$QDORJ,QS6HWXS
6LHPHQV 'XDO3DWK>@3DWK
(QDEOH6SDQDQDORJLQSXWFXUUHQW
,LQ   2II
!
$X[
6*
F6
F3
36,$
%$5$
7'HJ)
7'HJ&
2. Move the cursor down to [Aux] by pressing the <Down Arrow> and then press <ENTER>.
This enables the port to receive an input current. The cursor moves to [4 mA].
,LQ
6LHPHQV 'XDO3DWK>@3DWK
$VVLJQ$QDORJ,QSXW7\SH
,QSXW   $X[
P$
  
P$   