Siemens FUS1010 - Figure 5-11 Hi Precision Sensor Label

Connecting
5.5 Sensor Installation
FUS1010 IP65 NEMA 4X & IP66 NEMA 7
Operating Instructions, 01/2013, A5E02951520-AC
59


'
$
6LHPHQV,QGXVWU\,QF
0DGHLQ86$
66'7&6
%
66
UHY

;;;;+L3UHFLVLRQ
① Hi Precision sensor model number
② Sensor size
Figure 5-11 Hi Precision Sensor Label
Sensor Selection
The following is a typical sensor selection procedure.
Note
The tran
smitter must be powered up before you can select a sensor model. Refer to
Transmitter Wiring (Page 39).
1. Press <Left Arrow> to return to main menu. At [Meter Type], press the <Right Arrow> and
then <ENTER>.
2. The [Channel Setup] menu will appear.
3. Press the <Down Arrow> to select [install Sensor].
4. Press the <Right Arrow> to [Sensor Model]. Press <Right Arrow> and scroll to select the
sensor model number on the sensor label.