Siemens FUS1010 - Page 176

Troubleshooting
10.4 Site Setup Data
FUS1010 IP65 NEMA 4X & IP66 NEMA 7
Operating Instructions, 01/2013, A5E02951520-AC
175
I[GULYH  
1EXUVWOHQJWK  
/WQ   
9IPD[ 
9VPD[06  
9VPLQ06 
(PSW\  
6DPSOHV&\FOH  
0D['DPSLQJ
0LQ'DPSLQJ
+)   !
6LWH6HWXS'DWD
6LHPHQV 'XDO3DWK>@$%&
Automatic Adjustment Procedure
1. In the [Site Setup Data] Menu, press the <Down Arrow> and scroll to the [HF] menu cell.
Press the <Right Arrow> and a pop-up [Manual] prompt will appear.
2. Press the <Up or Down Arrow> to select [Automatic] then press <ENTER>.
3. The current measured correction value is displayed (see below).
4. Press <ENTER> again to install this correction value which will now appear next to the
[HF] menu cell.