Troubleshooting
10.5 Force Transmit
FUS1010 IP65 NEMA 4X & IP66 NEMA 7
178 Operating Instructions, 01/2013, A5E02951520-AC
Note
The <ALT> and <MENU> keys must be pressed before the flow meter scans through all
the drives, or the Force Transmit function must be initiated again.
2. A typical menu screen will appear as shown below and indicate the current ALC (e.g.,
50). This ALC number indicates the current receive signal strength and can be used for
further diagnostic purposes.
6LHPHQV 'XDO3DWK>@ $%&
)RUFH1I[ P $/&
,QVWDOO6HQVRU
,QVWDOO3DWK
6HQVRU0RGHO +37
6HQVRU6L]H %
6HQVRU0RXQW0RGH 'LUHFW
6SDFLQJ2IIVHW0LQLPXP
1XPEHU,QGH[
6SDFLQJ0HWKRG 6SDFHU%DU73
/WQ9DOXHLQ
(PSW\3LSH6HW&KDQQHO1RW6HWXS
=HUR)ORZ$GMXVW &KDQQHO1RW6HWXS
,QVWDOO&RPSOHWH ,QVWDOO
6LHPHQV 'XDO3DWK>@ $%&
,QVWDOO6HQVRU
,QVWDOO3DWK
6HQVRU0RGHO +37
6HQVRU6L]H %
6HQVRU0RXQW0RGH 'LUHFW
6SDFLQJ2IIVHW0LQLPXP
1XPEHU,QGH[
6SDFLQJ0HWKRG6SDFHU%DU73
/WQ9DOXHLQ
(PSW\3LSH6HW&KDQQHO1RW6HWXS
=HUR)ORZ$GMXVW &KDQQHO1RW6HWXS
,QVWDOO&RPSOHWH ,QVWDOO
'HWHFWLRQ)DXOW
3UHVV>(17@
3. To exit Force Transmit, press the <Left Arrow> and a Detection Fault prompt will appear
(see above).
4. Press the <Left Arrow> again and the meter will return to the [Install Sensor] menu and
highlight the [Empty Pipe Set] menu cell.
Setting a Forced Frequency
1. To force a frequency, repeat steps 1 and 2 above, but press <Right Arrow>. The following
typical display line will appear: Drive =0
2. Using numeric keys enter the frequency and press <ENTER>.
3. To complete the Install process after mounting the transducers press <ENTER>.
4. If the Force Transmit diagnostic procedure is not used, the normal [Install Complete]
function occurs.
To Next Page
Loading...
