Safety notes
2.6 Safety Notes
FUS1010 IP65 NEMA 4X & IP66 NEMA 7
Operating Instructions, 01/2013, A5E02951520-AC
19
, understand and follow all safety instruction on the electronic media provided. This
ent is rated for use in hazardous (classified) locations as stated below and must be
ed on the media. Failure to
safe operation. Follow all local
en properly installed the
equipment meets the following FM – CSA ratings:
B, C and D;
2, Groups E, F and G outdoor (Type 4X), Class III (CSA
● Temperature code T6 at an ambient of 40°C
c media provided. This
elow and must be installed
t in the prescribed manner will result in unsafe operation. Follow all regional safety
y installed the equipment meets the
mination Certificate KEMA03ATEX1134
gs and Explanations
FM-CSA installation
Read
equipm
installed according to the 1010-443 installation drawing provid
install the equipment in the prescribed manner will result in un
jurisdictional safety codes when operating this equipment. Wh
Transmitter
● Explosionproof for Class I, Division1, Groups B, C, D;
● Dust-ignitionproof for Class II, Division 1, Groups E, F and G
● Intrinsically safe connections for Class I and II, Division 1, Groups A, B, C, D, E, F and G;
● Nonincendive for Class I, Division 2, Groups A,
● Suitable for Class II, Division
only)
Sensors
● Intrinsically safe Class I and II, Division 1, Groups A, B, C, D, E, F and G;
● Nonincendive for Class I, Division 2, Groups A, B, C and D;
● Suitable for Class II, Division 2, Groups E, F and G outdoor (Type 4X), Class III (CSA
only)
ATEX installation
Read, understand and follow all safety instruction on the electroni
equipment is rated for use in explosive atmospheres as stated b
according to the 1010-464 installation drawing provided on the media. Failure to install the
equipmen
laws when operating this equipment. When properl
following ATEX ratings as stated in EC-Type Exa
Transmitter Markin
●
II (1) G [Ex ia] IIC– Transmitter located in the non-hazardous area with intrinsically
safe circuits of category Ex ia, which can be connected to Category 1 Sensors for use in
potentially explosive atmosphere containing gases
●
II 3 (1) G Ex nC [ia] IIC T5 (Tamb = 0° To + 60°C) – Category 3 Transmitter locate
Zone 2 potentially explosive atmosphere with intrinsically safe circuits of category Ex ia
d in
,
which can be connected to Category 1 Sensors in Zone 0 for use in potentially explosive
●
atmosphere containing gases
II 2 (1) G Ex d [ia IIC] IIB T5 (Tamb = 0° To + 50°C) – Category 2 Transmitter located
in Zone 1 potentially explosive atmosphere with intrinsically safe circuits of category Ex
ia, which can be connected to Category 1 Sensors for use in potentially explosive
atmosphere containing gases
To Next Page
Loading...
Need help?
General
