Appendix
A.3 RS-232 Connection
FUS1010 IP65 NEMA 4X & IP66 NEMA 7
Operating Instructions, 01/2013, A5E02951520-AC
211
SITE
Invokes a full site download for a single channel or multi-path 1010 flow meter.
SITE "n"
Invokes a site download for channel "n", where "n" = the Channel # (1, 2, 3, 4, etc.).
DP "n"
Commands the flow meter to download the digitized receive signal data for Channel or Path
"n".
CLRTOT
Clears the Totalizer for a single channel or multi-path 1010 flow meter.
CLRTOT "n"
Clears the Totalizer for Channel "n" of a multi-channel flow meter.
Lf on
Turns on the Line Feed at the end of any text string sent by the flow meter.
Lf off
Turns off the Line Feed at the end of any text string sent by the flow meter.
?
Provides a list of available Terminal Mode flow meter commands.
Transferring information from a 1010 flow meter to the PC
With HyperTerminal active:
1. Point to [Transfers], and click.
2. Select [Capture Text].
3. Select desired drive path or directory, enter a file name, and click the Start button.
4. Use the following conventions for data file names:
– For site data or Wave shape data: filename.txt
– For Datalogger data: filename.csv
5. On the PC type the proper command for the data desired (Logger, Site, or DP) and then
press [Enter] key.
6. The data should begin streaming on the HyperTerminal screen.
To Next Page
Loading...
Need help?
General
