6. Click "Next >".
The "Select the network connections for the S7 programs associated with the areas" dialog
box opens. In the "S7 programs and network connections" group. You will find the "s7
PROGRAM(1)" entry and the "S7 connection_1" subnet. This connection is used by the
automation system and operator station for communication, which you have already
created in NetPro.
7. If no connection is displayed here, click "Connection...". Select the S7 connection you have
made in NetPro from the "Select network connection" dialog box and then click "OK". The
selected connection is entered.
8. Click "Next".
The "Select the data you want to compile and the scope of the compilation" step is displayed.
9. Activate the following check boxes and option buttons as shown in the figure below:
Configuring the operator station
9.4 Working in the SIMATIC Manager
PCS 7 SMART Getting Started - Part 1 (V9.0 with APL)
Getting Started, 12/2017, A5E42181435-AA 149
To Next Page
Loading...
Need help?
General
