11.6 Starting process mode
Prerequisites
● The OS is compiled.
● The color_gs project is open in WinCC Explorer.
● The follow-up work has been performed in the "RMT2" process picture.
Procedure
1. Select File > Activate in WinCC Explorer.
This function changes to operation in process mode. The overview area displays a button
named "RMT2". You monitor the units separately by toggling the views using the "RMT1"
and "RMT2" buttons. The button of the unit which is currently visualized is marked with a
color.
2. Click "RMT2" in the overview area.
3. Change the button set, followed by "SFC Visualization".
The "Open SFC" dialog box opens. The detail view shows two SFC charts: the SFC chart
from "RMT1" and the SFC chart from "RMT2".
4. Select SFC chart "../RMT2" and start the sequential control system.
For more information, refer to AUTOHOTSPOT.
5. Perform the following steps in process mode:
– Switch between the plant units.
– Change the setpoint presetting.
– Specify the reactor selection.
6. For more information, refer to AUTOHOTSPOT.
Performing the additional task
11.6 Starting process mode
PCS 7 SMART Getting Started - Part 1 (V9.0 with APL)
Getting Started, 12/2017, A5E42181435-AA 195
To Next Page
Loading...
