Siemens SIMATIC PCS 7 SMART User Manual

10.2.4 Stopping the process
Procedure
To stop the running proces manually:
1. Click "Stop" in the detailed display of the SFC chart.
The "SFC Operation" dialog box opens.
2. Click "OK".
This stops the process.
3. Now, click "Reset" and then "OK" in the "SFC Operation" dialog box.
This resets all values to the input values.
10.2.5 Controlling the process by means of the process picture
Operator process control
There are several ways of influencing the process in the process mode using the process
picture:
● Select Reactor (Page 177)
● Open Faceplate (Page 178)
● Define Setpoint Value (Page 178)
10.2.6 Specifying the reactor
Procedure
1. Click on the "PARA_DOS_RM1_SEL" block icon.
The associated faceplate opens.
2. Click "Command".
3. Check the reactor in which you want to dose the raw material:
– Reactor 1 selected: "Off" command
– Reactor 2 selected: "On" command
If you want to select the other reactor, proceed as follows:
– Click "..." next to "Command".
The faceplate is expanded.
– Click "On" if Reactor 2 should be selected.
Working in runtime
10.2 Operator control and monitoring in process mode
PCS 7 SMART Getting Started - Part 1 (V9.0 with APL)
Getting Started, 12/2017, A5E42181435-AA 177

Siemens SIMATIC PCS 7 SMART Specifications

General

Brand	Siemens
Model	SIMATIC PCS 7 SMART
Category	Control Systems
Language	English