4. This view is similar to the display that you worked when testing the SFC in the SFC
Editor.
5. Position this detailed display so that you can see your entire process picture.
6. Click "Start".
The "SFC Operation" dialog box opens.
7. Click "OK".
The sequential control system starts: You can monitor the process in your process picture
and in the detailed display of the SFC. The representation in the SFC is identical to the
representation of the test mode.
Note
A simulated value is used, beginning with "INPUT_U", since a real value is not yet available.
The use of a simulated value is then indicated in WinCC by a yellow hand (icon) and by a
warning triangle on the tank.
Note
The symbols for alarm and warning on the block icons flash at the beginning, since the tank
is slightly overfilled.
Working in runtime
10.2 Operator control and monitoring in process mode
PCS 7 SMART Getting Started - Part 1 (V9.0 with APL)
176 Getting Started, 12/2017, A5E42181435-AA
To Next Page
Loading...
