03.2010 Parameterization
Siemens AG 6SE7087-6QX70 (Version AL)
SIMOVERT MASTERDRIVES Compendium Motion Control 5-31
5.4.4.2 Changing slaves
During bus operation, a specific slave can be selected via the OP1S
with the "Change slave" function without any re-plugging. Starting from
the basic menu, the "Change slave" function is selected with the
"Lower"/"Raise" key and activated with "P". The user is then requested
to enter a slave address.
MotionControl
Download
Delete data
#Change slave
P
Change slave
Address:00
Example of activating the "Change slave" function
After the slave address has been entered with "Raise"/"Lower" and
confirmed with "P", a change is made to the required slave and the
display returns to the basic menu. If the slave cannot be found, an error
message is output.
5.4.5 Technical data
Order number 6SE7090-0XX84-2FK0
Supply voltage 5 V DC ± 5 %, 200 mA
Operating temperature 0 °C to +55 °C
Storage temperature -25 °C to +70 °C
Transport temperature -25 °C to +70 °C
Environment class
• Humidity
• Pollution resistance
Acc. to DIN IEC 721 Part 3-3/04.90
03K3
13C3
Protection class
II acc. DIN VDE 0160 Part 1/05.82
IEC 536/1976
Degree of protection
• Front
• Rear
Acc. to DIN VDE 0470 Part 1/11.92
IP54 EN60529
IP21
Dimensions W x H x D 74 x 174 x 26 mm
Standards VDE 0160/E04.91
VDE 0558 Part 1/07.87
UL, CSA
Table 5-11 Technical data
To Next Page
Loading...
