Siemens simovert masterdrives

08.2012 Technology Option F01
Siemens AG 6SE7087-6QX70 (Version AN)
SIMOVERT MASTERDRIVES Compendium Motion Control 9-1
9 Technology Option F01
9.1 Enabling technology option F01
Technology option F01 can only be used on a MASTERDRIVES unit if
the unit was supplied from the plant of manufacture with option F01
already enabled or if the option was enabled afterwards by entering a
PIN number. Please consult sheet [850] of the function diagram to find
out
♦ Whether option F01 is enabled on your MASTERDRIVES unit
♦ How to enable option F01 temporarily as a "demo version" for a
period of 500 hours using the special PIN number
♦ How to enable option F01 as a "full version" after the
MASTERDRIVES unit is supplied
9.2 Overview of the documentation
The figure below shows you an overview of the documentation
available for technology option F01:
MASTERDRIVES MotionControl
Compendium
- Technology option F01
- Application areas
- Brief description of positioning, synchronization
and encoder/position sensing
- Communication with the technology
- Configuration and application examples
- Commissioning, faults, warnings, diagnostics
- Function diagrams
Order number:
:
6AT1880-0AA00-1AE0 (German)
6AT1880-0AA00-1BE0 (English)
Motion Control Manual
Detailed Technical Reference Manual /1/
- Part 1: Technology Functions:
- Programming Guide - Writing NC Programs
- Part 2: SIMATIC S7 Communication Functions
- GMC-BASIC Standard Software (Configuring Package)
- Task Description
- Part 3: User Interfaces
- Motion Control HMI Package (GMC-OP-AM standard software with
standard screens for OP25, OP27, OP37, TP37, etc.)
This manual is an essential requirement!
for MASTERDRIVES MC
and SIMATIC M7
- Parameter lists
- Faults and warnings
Function diagrams of technology [799...850]
Parameters of technology (U500...U799)
Faults and warnings of the technology (A129...A255)
- Function Description - Positioning and Synchronization
Chapter 9
Fig. 9-1 Overview of the documentation for technology option F01