Communication / PROFIBUS 09.2008
6SE7087-6QX70 (Version AK) Siemens AG
8.2-58 Compendium Motion Control SIMOVERT MASTERDRIVES
Optional
boards?
yes
Possible optional boards:
SCB, TSY, CBP, TB
P052 = 4
Function selection
"Hardware configuration"
no
P696 = x
P698 =
.
P705 =
P918 = n
P052 = 0
Optional for start-up
diagnosis
CBP bus address
0 < n < 126
P697 = 2 ... 5
Optional; if PPO type
cannot be set via
PROFIBUS-DP
master
P053 = x
P052 = 5
Parameter access CBP
Function selection "Drive setting"
Leave
"Hardware configuration"
CBP in
slot +1.B2?
no
nein
CBP in
slot +1.B3?
yes
P090 = 1
yes
P091 = 1
CBP in slot +1.B3
CBP in slot +1.B2
yes
Reserved
.
Reserved
Fig. 8.2-19 Parameterization of "Hardware configuration" for FC (CU1), VC (CU2) and
SC (CU3)
All grayed out parameters are only valid for units with the functions FC
(CU1), VC (CU2) and SC (CU3).
Basic
parameterization for
FC (CU1), VC (CU2)
and SC (CU3)
NOTE
To Next Page
Loading...
Need help?
General