Technology Option F01 08.2012
6SE7087-6QX70 (Version AN) Siemens AG
9-184 Compendium Motion Control SIMOVERT MASTERDRIVES
♦ U422.01-03 Input position actual value, actual speed and position
setting value for the real master
♦ U423 Input smoothing for position actual value input of the
real master
♦ U424 Deadtime compensation for real master
♦ U425.01-02 Axis cycle length at the input and output of the real
master
♦ U426 Selection of connector "Set output" for real master
♦ U427 Smoothing of the speed signal for the real master
♦ U428 Speed normalization in the real master
♦ U625.01-03 Catch-up control word
♦ U626.01-03 Catch-up setpoints (setpoint speed and halt position)
♦ U627.01-02 Rounding time constants for the halt and catch-up
ramp in the catch-up function
♦ U628.01-02 Deceleration/acceleration for the halt and catch-up
ramp in the catch-up function
♦ U672 Selection of the "Set displacement" binector in the
displacement angle setting
♦ U675.01-02 Selection of the "Enable position correction" and
"Enable referencing" binectors for synchronization
(parameter now indexed, index .02 is new)
♦ U676 Selection of the "Synchronize to master value"
binector
♦ U677.01-02 Fixed setpoints for absolute and relative displacement
angle
♦ U678.01-03 Selection of the following connectors for displacement
angle setting: "Absolute displacement angle",
"Displacement setting value" and "Relative
displacement angle".
♦ U688.01-02 Fixed setpoints for catch-up speed and catch-up
position
♦ U694.01-02 Selection of "Start+" and "Start-" binectors for relative
displacement angle setting
♦ U695.01-03 Speed, deceleration and acceleration for
"Displacement angle inching"
♦ U696.01-02 Selection of "Inching+" and "Inching-" binectors for
displacement angle setting
♦ U697.01-02 Acceleration and variable speed for compensation
movement of displacement angle setting
♦ U698.01-02 Selection of connectors for variable speeds for
displacement angle setting
♦ U699.01-02 Operating mode of synchronization to master value
and absolute displacement angle setting
New parameters
To Next Page
Loading...
Need help?
General