Commissioning
4.4 Creating a project offline in Startdrive
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
113
Startdrive manages the motor data of numerous motors in a motor list. Motors can therefore
be quickly specified via the Inspector window. If you want to manage the motors in your
device configuration that are not contained in the motor list, you can acquire the most
important motor data, such as the rating plate values of the motor, manually in the Inspector
window.
● A project has been created.
● The Control Unit is inserted in the device configuration.
● A Motor Module or a Power Module is inserted.
● An infeed is inserted.
In case of doubt, you can also add the infeed at a later point in time. However, in this
case, you must manually wire the "infeed" component with the other components.
● An encoder is inserted (optional).
To Next Page
Loading...
