Startdrive commissioning tool
2.5 User interface - trace function
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
53
Measurements (overlay measurements)
The "Measurements" tab displays the individual measurements and among other things
provides the setting options for synchronization.
Setting options and displays in the "Measurements" tab
The following figure shows the display in Startdrive as example:
Trigger/measurement point
Alignment of the measurements in accordance with the trigger or measurement point. The indi-
vidual zero point for the measurement is predefined in the table under the “Alignment” column.
Time stamp (absolute time)
Alignment of the measurements in accordance with their time stamp. The signals are aligned in
accordance with the time from the absolute time stamp.
The following table columns are displayed:
• Name
Display and change options for the measurement name.
• Alignment
Determines the individual zero point for a measurement. All signals for the measurement
are displayed in relation to this zero point.
• Offset
Moves the measurement left or right by the offset stated on the time axis.
• Time stamp
Display of the trigger time
• Comment
Display and input option for a comment about the signal
Figure 2-14 Tab Measurements
To Next Page
Loading...
