Diagnostics
5.3 Diagnostics via Startdrive
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
347
Or:
1. In the
"Measurements" system folder, select a measurement .
2. Double-click the selected measurement.
3. If required, activate the icon
for monitoring.
4. Check to ensure that the signals (
) are shown in the "Diagram" tab in the signal table.
You can display the signals via the shortcut menu.
The recording is displayed in the "Diagram" tab.
Saving measurements in the project
Requirement
● An online connection has been established to the drive.
● A recorded trace is saved in the drive.
● The data of the trace in the drive must of been displayed at least once in the curve
diagram. For display, the recorded data are loaded from the drive.
To save a recording in the project, proceed as follows:
1. Open the trace in the drive with the recorded data (see Chapter "Creating or calling a
trace (Page 339)").
2. Ensure that the actual data from the drive are loaded by activating icon
.
3. After activating icon
wait until all data have been loaded and displayed.
4. Click on icon
.
The measurement is added to the
"measurement" system folder.
5. Save the project in Startdrive.
To Next Page
Loading...
