Siemens SINAMICS S120 - Permanently Save the Settings

Fundamentals
3.5 Permanently save the settings
Commissioning with Startdrive
72 Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
3.5
Permanently save the settings
Saving configurations in the project
In Startdrive, settings are predominantly made via screen forms. The complete project must
be saved in order that the settings made are permanently active.
1. Click "Save project" in the toolbar.
- Or -
2. Select the "Project > Save" or "Project > Save as" menu.
Non-volatile saving to memory card
The settings during parameterization are only saved volatile. They are lost when you switch
off the drive unit.
Saving online data:
Click the icon in the function view of the active Startdrive project.
The current project settings are stored non-volatile on the memory card of the drive unit.
Saving offline data:
For storing in a power-independent manner, it is important that the settings made are not
only saved in the project on the PC, but are also stored permanently on the memory card of
the drive unit (also known as "Copy RAM to ROM"). An online connection must be
established to the drive unit for this purpose.
1. Establish an online connection (Page 137) to your drive unit.
2. Load the project data in your drive unit(s).
Proceed as described in Chapter "Loading the project to the target device (Page 207)" for
this purpose.
3. Click the
icon in the function view of the active Startdrive project.
The current project settings are stored non-volatile on the memory card of the drive unit.