Startdrive commissioning tool
2.3 User interface - parameterization
Commissioning with Startdrive
36 Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
Configure the drive line-up in the "Device view". You insert components and edit the DRIVE-
CLiQ connections. You can call the device view by double-clicking the "Device configuration"
entry in the project tree.
The device overview provides a tabular overview of all configured components and their
data.
The following figure shows an overview of the device view.
Bus interface, PROFINET in this case
Motor Modules, Power Modules
Zoom, enlarge and reduce the graphic display
Figure 2-4 Device view
To Next Page
Loading...
