Siemens SINAMICS S120 - Control Interface Module in the Power Module Chassis Format

Diagnostics
5.2 Diagnostics using LEDs
Commissioning with Startdrive
320 Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
5.2.2.11
Control Interface Module in the Power Module chassis format
Table 5- 18 Meaning of the LEDs "READY" and "DC LINK" on the Control Interface Module in the Power Module
LED, state
Description
READY
DC LINK
Off Off The electronic power supply is missing or lies outside the permissible tolerance range.
Green Off The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
Orange The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The DC link voltage is present.
Red The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The DC link voltage is too high.
Orange
Orange
DRIVE-CLiQ communication is being established.
Red --- At least one fault is present in this component.
Note
:
LED is controlled irrespective of the corresponding messages being reconfigured.
Flashing
light
0.5 Hz:
Green / red
--- Firmware is being downloaded.
Flashing
light 2 Hz:
Green / red
--- Firmware download is complete. Wait for POWER ON.
Flashing
light 2 Hz:
Green /
orange
or
red / orange
--- Component detection using LED is activated (p0124).
Note
:
Both options depend on the LED status when module recognition is activated via p0124 = 1.
Table 5- 19 Meaning of the LED "POWER OK" on the Control Interface Module in the Power Module
LED
Color
State
Description
POWER OK Green
Off
DC link voltage < 100 V and voltage at -X9:1/2 less than 12 V.
On
The component is ready for operation.
Flashing
light
There is a fault. If the LED continues to flash after you have performed a
POWER ON, please contact your Siemens service center.