Siemens SINAMICS S120 - Making Detailed Settings

Commissioning
4.4 Creating a project offline in Startdrive
Commissioning with Startdrive
108 Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
4.4.5.3
Making detailed settings
Further detail settings can be carried out in the inspector window for Motor Modules and
Power Modules:
● Motor Module settings/Power Module settings
Allows the modification of the preallocated supply voltage.
Indicates the standard for power settings of converter and motor.
● Motor Module additional data/Power Module additional
Allows filter settings for modules of the VECTOR-type drive object.
The procedure for detail settings is identical for Motor Modules and Power Modules.
Procedure
Parallel connection using a Power Module as an example is explained below.
1. Select the desired Power Module in the device view and open the inspector window.
2. Select the menu "Power Module Details > Power Module Settings" in the inspector
window.
The preallocated supply voltage is displayed in the screen forms:
Figure 4-24 Example: Power Module Settings
3. Enter a new supply voltage as required.